24H Service:
+86-13585569799
Your Position: Home > Product >

What to do if the dust of the crusher is too large

  • Introduction to the maintenance method of cone crusher

    Apr 29, 2021· 5. Water in the oil of the crusher will cause the oil level of the oil tank to rise. The water pressure in the cooler is higher than the oil pressure, the water leakage of the cooler, the water supply of the water seal is too large, or the water supply pipe is blocked can cause water to be mixed in the cone crushing oil, and the oil level in the oil tank is "forced to rise".

  • P&Q University Lesson 7- Crushing & Secondary Breaking

    Sep 02, 2019· Also, dust that gets inside the crusher increases wear. But if systems are put in place to remove the dust, it should keep it from going into the machine in the first place. Dust also is a hazard on walkways and a problem for conveyors.

  • How to Solve the Dust Problem on Stone Crusher Plant

    We cancel one screw conveyor and raise the bag dust collector, which is beneficial to the arrangement of air inlet pipe (the angle of the air duct is large). The air inlet is equipped with the air inlet box, which makes the dust of the crusher feeding port directly enter the air inlet box of the dust

  • 14 Cone Crusher Common Problems And How To Fix Them M&C

    Jul 22, 2019· For the 5 reasons, we should do the following before turning on the cone crushers: First of all, before starting up, check to see if there is any residue in the tapered discharge opening, clean it up immediately, and pay attention to control the feeding evenly, not too much or too little.

  • Crushing Plant--Hydraulic Cone Crusher

    8. crusher vibrates strongly 1. Oil lack or dust in oil between Too fast cone rotation main unit and bushing Stop the machine, check the 2. bowl tile damaged causes and do the needful 3. not enough gap between cone bushing

Online Consultation Contact Details QR Code

Service Hotline

+86-13585569799

Scan to contact us